Ozone Tile Adhesive

For interior and exterior fixing of ceramics, marble, and decorative cladding.

 

Download “Ozone Tile Adhesive Flyer” Ozone_Tile_Adhesive.pdf – Downloaded 187 times – 409 KB

Description Ozone Tile Adhesive is a high-performance tile fixing adhesive for internal wall/ floor & external flooring & Tile-on-Tile Applications. Ozone Tile Adhesive is a blended polymer-modified cement-based powder tile adhesive. It gives excellent bonds on cementitious surfaces like concrete, plaster, etc. Ozone Tile Adhesive forms a waterproof barrier between two surfaces and has excellent ‘grab’ properties.
Uses For fixing all types of tiles on the internal wall/floor, external floor & tile on tile applications. As well as swimming pool tiling applications.
Features / benefits Ready to use, needs only mixing with water.

Excellent adhesion, low shrinkage.

Suitable for indoor and tile on tile applications.

Sufficiently flexible to accommodate physical & thermal movements.

Needs no curing, needs no hacking or mechanical key on the surfaces.

Soaking of tiles & backing of surface not required.

Properties

Appearance Cement grey powder
Mix ratio Powder: water 3: 1 (by vol)
Open time Approx 10 – 15 minutes at 30°C
Pot life Approx 2 hrs at 30°C
Coverage 45 – 50 sqft/20Kg Bag at 3 mm thickness
Traffic able time 24 hrs

 

Packaging: 25 kg bag.
Storage: Store in a dry and cool place below 35°C. Protect from direct sunlight.
Shelf Life: 1 year in original, unopened packaging.
Directions for use: Surface preparation: The surface to be tiled should be clean and sound. Old surfaces must be free from wax, grease, polish, etc. Pour one 25 kg bag in approx. 6 to 7 ltr of clean water (recommended proportion approx. 3:1 of powder to water by volume) at site, addition of water shall be adjusted to attain desired consistency. Do not put water into the powder. Mix with an electric fitted trowel or by hand until a lump-free homogeneous paste is obtained. Always mix the required quantity, which can be consumed within the prescribed pot life. Spread the adhesive to a thickness of approx. 3-6 mm and comb with a notched trowel. Strictly apply the adhesive paste which can be tiled within 10 to 15 minutes. Intermittently touch the adhesive paste on the substrate by finger. If the adhesive sticks to fingers then continue tiling and if not scrape off the adhesive and apply a new coat. Keep joints between two-tiles using spacers. Allow tiling to set for 24 hours and start filling joints the next day with Ozone Tile Grout. Use mechanical clamps for holding the heavy stones in positions on vertical surface. Ozone Tile Adhesive also can be applied at 3-mm thickness for fixing normal tiles in toilets and swimming pool areas. After grouting clean and polish tiles with a damp sponge or cloth.

Placing: Ozone Tile Adhesive can be applied directly to concrete, cement, screeds, and cement or lime mortar. Special attention must be given to new construction prior to commencing fixing of tiles should not be placed on concrete or blockwork until all shrinkage movement has taken place.

Note: Ozone Tile Adhesive should not be used directly on gypsum or gypsum board substrates. Please contact your local Ozone team for advice.

Finishing: Remove excess adhesive with a damp cloth before the material has set. Joint grouting with Ozone Tile Grout may be commenced 24 hours after tile has been laid.

Cleaning: Ozone Tile Adhesive should be removed from tools, equipment, and mixers with clean water immediately after use. Cured material can only be removed mechanically.

Cleaning & disposal: Tools and application equipment should be cleaned with water. Cured material can only be removed mechanically. Spillages should be absorbed with sand or sawdust and disposed of in accordance with local regulations.
Precautions / Limitations: If any doubt arises concerning temperature or substrate conditions, consult Ozone’s technical department.
Health & Safety: In case of contact with the skin, wash immediately with soap and water, In case of contact with the eyes rinse immediately with plenty of water and seek medical advice. If swallowed seek medical attention immediately, do not induce vomiting. Skin barrier cream, safety goggles, and rubber gloves are recommended. carried out in accordance with local legislation under the guidance of the local waste regulatory authority.

 

WARRANTY: Ozone products are guaranteed against defective materials and manufacture and are sold subject to their standard terms and conditions of sale. Ozone makes no warranties, implied or otherwise, as to the merchantability or fitness for ordinary or particular purposes of its products and excludes the same. If any Ozone product fails to conform to this warranty, Ozone will replace the product at no cost to the Buyer. Replacement of any product shall be the sole and exclusive remedy available and the buyer shall have no claim for incidental or consequential damages. Any warranty claim must be made period from the date of the claimed breach. Ozone does not authorize anyone on its behalf to make any written or oral statements which in any way alter Ozone’s installation information or instructions in its product literature or on its packaging labels. The user of the Ozone products must test the products for suitability for the intended application and purpose before proceeding with the full application of the products.